Bulk Configuration Transfer Utility Procedure - Emerson HART CAM216 Instruction And Operation Manual

Section 13: AMS Bulk Transfer
January 2016, Rev. 1
13.2

Bulk Configuration Transfer Utility Procedure

13.2.1 To transfer parameter data from the user configuration with the bulk transfer utility,
Figure 85
13.2.2 Before sending the configuration, the device must be placed into "Setup" mode,
Figure 86
78
create a new spreadsheet on Microsoft Excel. On the spreadsheet, use column 1
for "User Configuration" and Column 2 for "Host Tags". Once all the information is
entered, save the document.
Transfering Parameter Data
This can be done from AMS Device manager by opening the desired device DD and
navigating to "Configure > Manual Setup > Detailed Setup" and use the configuration
commands to place the device into "Setup Mode"
Entering Setup Mode
13.2.2.1 Note that when device is this mode, Commands from the host will be
ignored. You might to back to Overview Menu to verify the device is in setup
mode.
CAM216/16 IOM
Doc. Number: ECM-402-0116
AMS Bulk Transfer