Table of Contents
Advertisement
CAM216/16 IOM
Doc. Number: ECM-402-0116
7.
2.2
Installation of HART CAM16 in HQ-DCM33 Unit
1.
2.
Figure 6
3.
Table 9.
Control Type
HART – Analog Control (Point-to-Point)
HART – Digital Control (Multi-Drop)
HART – Digital Control (Wireless THUM)
4.
Table 10.
4 – 20 mA
4 – 20 mA
Installation of CAM16
HART Digital Control (Wireless THUM)
Refer to
Section 12
for details about the THUM wiring and configuration.
Remove power from the device and open the top main cover to expose the internal
electronics. Locate the main DCM33 Board.
Locate J2 connector on DCM33 board and J3 connector on CAM16. Connect the
CAM16 on the J2 connector. Then, secure the CAM16 board using the 3 plastic screw
holders onto the DCM33 board.
J2 Connection for CAM16
Follow Step 4, 5 or 6 depending on your HART Network type:
HART Control Types (4)
HART Analog Control (Point-to-Point; Actuator Must be in Analog Control Mode)
a.
Connect the HART Analog 4 – 20 mA input signal as follows:
HART Control Types (2)
Section 2: Installation of CAM16
Step to Follow
Step 4
Step 5
Step 6
Connector J4, PIN 3
Connector J4, PIN 4
January 2016, Rev. 1
9
Advertisement
Table of Contents
