DDS Calorimeters CAL3K Series Operation Manual page 64

49 READ AMB TEMP.
This causes the display of the present ambient temperature until ESC is pressed.
50 READ MEMORY RESULT
The unit displays the Last result number and the result details in line #4.
Press ENTER to display the result before the last
The result can be printed with the F8 function key
51 READ FIRING VOLT
Type ESC to end the firing voltage display. The firing takes place automatically after a pre-set time.
52 PRT RESULT DAY:
Enter the day number 1-31 and all results recorded at this day are printed. The result memory should be
cleared every month, CMD=39.
53 PRT RTIME HEADER
The CAL3K has a REAL TIME (RT) printout facility. It must be enabled by selecting one of the 4 output
formats WXYZ, CMD=61. Then the header (Data descriptor) is printed. If the SET RTHEAD EN CP,
CMD=60 has a selection (C=Customer, P=Parameter) then this info id printed as well.
54 D1 PORT SPEED
This command sets the D1 RS232 port speed. The default is 19200Kb.
55 SET FILTER C,F:
The print outs can be filtered to exclude Calibrations (C) and Faults (F).
56 PRT A-H HEADER
The unit has 8 print (Output formats) named A-H. The format can be set by CMD=63, SET OUTFORM A-
H.
This command prints the header (a short text description of each format position) so you can see what
the data consist of.
57 PRT TODAY FORM:
Enter an output format A-H and all results for today are printed.
58 PRT CALORI INFO
The command prints the relevant CAL3K information, including parameters and customer setting. This
printout is included in the shipment.
59 PRT VESSEL INFO
This command prints the vessel information. The vessel must be in the well.
60 SET RTHEAD EN CP
The REAL TIME output (from 30 seconds before firing) can be preceded by Customer (C) and Parameters
(P). If none is desired enter anything but CP.
DDS CALORIMETERS OPERATIONS MANUAL V1.1
0
0
1
0
0
0
1
0
1
1
1
1
2022
Digital Data Systems (Pty) Ltd.
CAL3K Advanced Bomb Calorimeters
www.ddscalorimeters.com
Website: www.ddscalorimeters.com 59