Table of Contents
Advertisement
QB-78F1030
(1) TCN1, TCN2, TCN3
These are connectors for connecting a check pin adapter or emulation probe.
(2) OSC1
This is a socket for mounting the oscillator.
(3) CN6
This is a connector for the shipment inspection. It is not something that the user will need.
(4) POWER (Red LED)
This is an LED that shows whether the power supply of the QB-78F1030 is switched on.
LED State
Lit
Not lit
Blinking
(5) TARGET (Green LED)
This is an LED that shows whether the power supply of the target system is switched on.
LED State
Lit
Not lit
(6) Power switch
This is the power switch of the QB-78F1030.
It is OFF at shipment.
R20UT0289JJ0100 Rev. 1.00
Sep 30, 2010
Power switch ON
Power switch OFF or AC adapter not connected to QB-78F1030
Internal error occurred (Contact an Renesas Electronics sales representative or
distributor)
Target system power supply ON
Target system power supply OFF or target system not connected
CHAPTER 2 SETUP PROCEDURE
QB-78F1030 State
Target System State
Page 11 of 28
Advertisement
Table of Contents
