Sainlogic FT0300 User Manual page 7

1. BEFORE inserting the batteries, locate the dip switches on the
inside cover of the lid of the transmitter.
Figure 8 displays all four switches in the OFF position (factory
default setting).
2. Channel Number: The FT0300 supports up to eight
transmitters. To set each channel number (the default is
Channel 1), change Dip Switches 1, 2 and 3, as referenced in
Table 1.
3. Temperature Units of Measure: To change the transmitter
display units of measure (°F vs. °C), change Dip Switch 4, as
referenced in Table 1.
Figure 7
Figure8
7