Display Console Set Up - Sainlogic FT0300 User Manual

Professional wifi weather station with wireless 8 channel remote monitoring
Hide thumbs Also See for FT0300:
Table of Contents

Advertisement

3.4.2 Display Console Set Up

It is recommended to plug in the power supply to reduce the
battery consumption and extend the service life.
Note: The sensor array must be powered and updating before
powering up the console, or the console will time out searching for the
sensors. Power the console last.
Make certain the weather station sensor array is at least 3m away from
the console and within
30m of the console. If the weather station is too close or too far away, it
may not receive a proper signal. If you have more than one Thermo-
hygrometer transmitter, make sure they are all powered up and
transmitting on different channels.
Remove the battery case on the back of the display, as shown in Figure
11. Insert three AAA (alkaline or lithium)) batteries in the back of the
display console. The display will beep once and all of the LCD
segments will light up for a few seconds to verify all segments are
operating properly.
Note: The character contrast is best from a slightly elevated viewing
angle.
Replace the battery case, and fold out the desk stand and place the
console in the upright position.
Figure 11
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FT0300 and is the answer not in the manual?

This manual is also suitable for:

Sw2Sp2Du2Cr2No2Fr2 ... Show all

Table of Contents

Save PDF