Display Console Set Up - Sainlogic WS-0835 User Manual

Professional wireless weather station
Hide thumbs Also See for WS-0835:
Table of Contents

Advertisement

3.4.2 Display Console Set Up

It is recommended to plug in the power supply to reduce the
battery consumption and extend the service life.
Note: The sensor array must be powered and updating before
powering up the console, or the
console will time out searching for the sensors. Power the console last.
Make certain the weather station sensor array is at least 10' away from
the console and within
100' of the console. If the weather station is too close or too far away, it
may not receive a proper signal.
Remove the battery door on the back of the display, as shown in Figure
8. Insert three AAA (alkaline or lithium)) batteries in the back of the
display console. The display will beep once and all of the LCD
segments will light up for a few seconds to verify all segments are
operating properly.
Note: The character contrast is best from a slightly elevated viewing
angle.
Figure 8
8

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WS-0835 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF