Table of Contents
Advertisement
Quicksilver 905WE — System & Component Overview and Operation
Disinfect the Fresh Water System
The following is a recommended procedure to disinfect the fresh water system:
1. Flush the entire system thoroughly by allowing potable water to flow through it.
2. Drain the system completely.
3. Fill the entire system with an approved disinfecting solution. Check with your dealer for
recommended products, and follow the manufacturer's instructions.
4. After disinfecting, drain the entire system.
5. Flush the entire system thoroughly several more times with potable water.
Maintenance
Maintenance of the fresh water system will require you to check the fittings and hoses to make sure
that there are no leaks. Before the winter season, the fresh water system must be completely drained
to avoid damage.
City Water Inlet
Included in the boat is a City Water Inlet which allows you to hook up to a fresh water source while at
a dock. The inlet contains a pressure regulator to control the flow of water to your boat. To connect,
simply attach the male quick disconnect fitting (provided by Quicksilver®) to the City Water Inlet. Next
connect a water hose with a female quick disconnect fitting end to the City Water Inlet. The inlet
bypasses the water tank so there is no need to turn on the water pump.
Boiler (optional)
Your boat may come equipped with an optional 22L boiler, located in the starboard utility area in the
aft berth. To operate, make sure the FRESH WATER switch is in the ON position. Next, turn on the
WATER HEATER breaker located on the 230V main distribution panel.
The boiler's thermostat comes pre-set from the factory at 70
temperature, refer to the boiler's owners manual for explicit instructions.
Maintenance
Maintenance of the boiler will require you to check the fittings and hose connections regularly to
make sure that there are no leaks. The pressure relief valve must be activated regularly to make sure it
is not blocked. This must be done when the water in the boiler is cool. The system should be flushed
several times a year to prolong the life of the system.
Before the winter season, the boiler must be completely drained to avoid damage.
Boiler
o
C. If you would like to adjust the water
22L boiler
Water inlet (from water pump)
Relief valve
Water outlet (to hot water lines)
Engine heat exchanger inlet / outlet
23
Advertisement
Table of Contents
