Cockpit Sunshade (Optional) - Quicksilver 905WE Owner's Manual

Quicksilver 905WE — System & Component Overview and Operation
•
Remove the table legs (if installed), and install the short sun lounge legs.
•
Place the table into position. The table edges will sit on the edge of the cockpit seat base and
forward L-lounge seat.
•
Snap all cushions into place.
When not in use, the sun lounge table legs are stored in the fixed L lounge seat base.

29. Cockpit Sunshade (optional)

If installed, an optional cockpit sunshade is available to provide protection from the sun. The cockpit
sunshade consists of a rail in the hardtop and a canvas.
Operation
At the upper corner of the hardtop (port and starboard), there is a plate with a pin that holds the
sunshade rail in place. To extend the sunshade, simply pull the pin on both sides and slide the rail out.
The pins will re-engage and lock the rail when fully extended. To install the sunshade canvas, slide the
welting (piping) located on front edge of the sunshade through the sunshade track installed on the
hardtop. Next connect the sunshade to the sunshade rail using the zippers on the edge of the
sunshade. Finally, connect the sunshade straps to the eyelets on the deck.
Cockpit Sunshade
Sunshade rail
Pull pin (P&S)
Sunshade canvas
Do NOT run the boat while the aft cockpit seat is laying flat.
Quicksilver® recommends that when the engine is running,
the seat back is in it's most up-right position.
Sunshade strap (P&S)
Deck eyelets
In rough seas, the sunshade should be stored to avoid
damage to the rail and or canvas
56