Installing and Connecting the HP 600/610 External Power Supplies
Installation Procedures
W A R N I N G
For safe reliable installation, only use the screws provided in the
accessory kit to attach the mounting brackets to the unit.
N o t e
Note that the mounting brackets have multiple mounting holes and can be
rotated allowing for a wide variety of mounting options. These include
mounting the unit so that its front face is flush with the face of the rack, or
mounting it in a more balanced position as shown in the illustration above.
2.
Horizontal Surface Mounting
Place the unit on a table or other horizontal surface. The unit comes with
rubber feet in the accessory kit that can be used to help keep the unit from
sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the unit within the
embossed angled lines. Use a sturdy surface in an uncluttered area. You may
want to secure the EPS and RPS cables and the unit's power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
C a u t i o n
Make sure the air flow is not restricted around the sides and back of the unit.
2-8
Hold the unit with attached brackets up to the rack and move it vertically
until rack holes line up with the bracket holes, then insert and tighten the
four number 12-24 screws holding the brackets to the rack.