Back Of The Unit; Rps Ports On The Hp 600 Rps/Eps; Eps Ports On The Hp 600 Rps/Eps - HP ProCurve J8161A Installation And Getting Started Manual

Introducing the HP ProCurve 600/610 External Power Supplies

Back of the Unit

Back of the Unit
R1 R2
Device Connected
RPS 1 RPS 2
Power Status
RPS 1
Internal Power Status LED
EPS Backup Power Ports EPS Backup Power Ports
In In Ready Ready Out Out
Internal Internal
Power Power
Status Status
EPS Backup Power ports

RPS Ports on the HP 600 RPS/EPS

The HP 600 RPS/EPS has six redundant power supply ports. You can connect
up to six HP ProCurve switch units, but backup power can be supplied to only
one unit based on port priority. Port 1 has the highest priority and port 6 the
lowest. A switch connected to port 1 always receives power before any other
port. Likewise, port 2 receives power before ports 3 to 6, port 3 receives power
before ports 4 to 6, and so on down to port 6, which only receives power when
no other port is receiving power.

EPS Ports on the HP 600 RPS/EPS

The HP 600 RPS/EPS has two external power supply ports. You can connect
one or two HP PoE capable switches to provide PoE power as a primary or
backup source. Power is equally shared between the two EPS ports (204 W
each); one port supplies maximum power (408 W) if the other port is not used.
1-6
RPS port LEDs
R3 R4
RPS 3 RPS 4
RPS ports
EPS Backup Power port LEDs
Ready Ready
Multiple power sources disconnect both the AC cord and EPS Backup power cables to completely remove power from the unit.
EPS port LEDs
R5 R6
RPS 5 RPS 6 EPS 1
RPS 6
EPS ports
HP 600 RPS/EPS
Device
E1 E2
Connected
EPS 2
Power
Status
AC power
connector
HP 610 EPS
Line: 50/60 Hz
110 240 V~
11 6 A
AC power connector