Connecting Eps Ports To Switches - HP ProCurve J8161A Installation And Getting Started Manual

Installing and Connecting the HP 600/610 External Power Supplies
Installation Procedures

Connecting EPS Ports to Switches

To connect:
Push the EPS cable plug into the EPS
port until the tab on the plug clicks into
place. When power is on for the
HP 600 RPS/EPS or HP 610 EPS and for
the connected device, the Device
Connected LED should go on to confirm
a powered-on switch is at the other end
of the cable.
If the Device Connected LED does not
go on when the EPS cable is connected
to the port, see Diagnosing with the
LEDs in chapter 3, "Troubleshooting."
To disconnect:
Press the small tab on the plug and pull
the plug out of the port.
Refer to
power usage, and to
available PoE power.
2-10
"EPS Port Operation" on page 1-8
"Limitations" on page 2-18
R6 E1
EPS 1
EPS Cable:
• Only use the cables supplied with the unit
• The cable connectors are keyed and can
only be attached in one orientation
for detailed information and on PoE
for information on maximum
EPS 2