Table of Contents
Advertisement
SECTION H
INSTALLATION
24
INITIAL INSPECTION
2-2
Before shipment, this instrument was in¬
spected and found to be free of mechanical and
electrical defects.
As soon as the instrument is
received, proceed as instructed in the following
paragraphs.
2-3
MECHANICAL CHECK.
2-4
If external damage to the shipping carton is
evident, ask the carrier's agent to be present
when the instrument is unpacked.
Check the in¬
strument for external damage such as broken con¬
trols or connectors, and dents or scratches on the
panel surfaces.
If the instrument is damaged, file
a claim with the carrier's agent and notify your
local Hewlett-Packard Sales and Service Office as
soon as possible (see list at rear of this manual
for addresses).
2-5
ELECTRICAL CHECK
2-6
Check the electrical performance of the in¬
strument as soon as possible after receipt.
Sec¬
tion V of this manual contains performance check
procedures which will verify instrument operation
within the specifications stated in Table 1-1.
This
check is also suitable for incoming quality control
inspection.
Refer to the inside front cover of the
manual for the Certification and Warranty state¬
ments.
21
REPACKAGING FOR SHIPMENT
2-8
To insure safe shipment of the instrument, it
is recommended that the package designed for the
instrument be used.
The original packaging mater¬
ial is reusable.
If it is not available, contact
your local Hewlett-Packard field office to obtain
the materials.
This office will also furnish the
address of the nearest service office to which the
instrument can be shipped.
Be sure to attach a
tag to the instrument specifying the owner, model
number, full serial number, and service required,
or a brief description of the trouble.
2-9
INSTALLATION DATA
2-10 The instrument is shipped ready for bench
operation.
It is necessary only to connect the in¬
strument to a source of power and it is ready for
operation.
2-11 LOCATION
2-12 This instrument is convection cooled.
Suf¬
ficient space should be allotted so that a free flow
of cooling air can reach the top and rear of the in¬
strument when it is in operation.
It should be used
in an area where the ambient temperature remains
between 0°C and +55°C.
2-13 OUTLINE DIAGRAM
2-14 Figure 2-1 illustrates the outline shape and
dimensions of Models 6104A, 6105A, 6114A, and
6115A.
Figure 2-1.
Outline Diagram
2-15 RACK MOUNTING
2-16 The Model
6104A, 6105A, 6114A, and 611SA
power supplies may be rack mounted using either
the dual rack adapter kit or the combining case
(with appropriate cooling kit) described in para¬
graph 1-20.
The necessary installation instruct¬
ions are provided with the accessories.
247
INPUT POWER REQUIREMENTS
2-18
Models 6104A, 6105A, 6114A, and 6115A may
be operated continuously from either a nominal 120
volt or 240 volt, 48-440Hz power source.
A two-
position selector switch (f) located within the
a-c power module on the rear panel selects the
power source.
Before connecting the instrument to
Advertisement
Table of Contents
