Connect To Switches; Connecting Rps Ports To Switches - HP ProCurve J8161A Installation And Getting Started Manual

3. Connect to Switches

Connect the EPS and RPS cables from the supported network switches to the
appropriate ports on the HP 600 RPS/EPS and HP 610 EPS.

Connecting RPS Ports to Switches

To connect:
Push the RPS cable plug into the desired
RPS port until the thumb screws engage
with the screw holes in the unit. Tighten
the plug thumb screws to secure the
connection.
When power is on for the HP 600 RPS/
EPS and for the connected switch, the
Device Connected LED should go on to
confirm a powered-on switch is at the
other end of the cable.
If the Device Connected LED does not
go on when the RPS cable is connected
to the port, see Diagnosing with the
LEDs in chapter 3, "Troubleshooting."
N o t e
Connect switches to the RPS ports based on their priority, with the highest
priority switch connected to port 1.
To disconnect:
Unscrew the thumb screws on the plug and pull the plug out of the port.
Installing and Connecting the HP 600/610 External Power Supplies
RPS Cable:
• Only use the cables supplied with the unit
• The cable connectors are keyed and can
only be attached in one orientation
Installation Procedures
R3 R4
3 RPS 4 RPS
2-9