Install An Optional Transceiver; Installing Transceivers - HP ProCurve 224 Installation Manual

2. Install An Optional Transceiver

Install optional transceiver modules into the transceiver slot by following the
instructions in the manuals that accompany these products.
The slot cover can be removed with either a flat-bladed or Torx T-10 screw-
driver. Retain the slot cover for future use.
C a u t i o n
To avoid damage to circuitry in the switch and any modules, always
unplug the power from the switch before installing or removing a
transceiver module into the transceiver slot, and when removing any
modules.
If you do not install an optional transceiver, make sure that the cover plate is
still attached over the slot for safe operation and proper switch cooling.

Installing Transceivers

Supported Transceiver Models: Install either of these HP 100Base-T
transceiver modules into the transceiver slot:
- HP J3192C 10/100Base-TX Twisted-Pair Transceiver Module
- HP J3193B 100Base-FX Fiber-Optic Transceiver Module
C a u t i o n
Make sure you install only the "B" model or later version of the
100Base-FX Fiber Optic transceiver module, and the "C" model or
later version of the 10/100Base-TX Twisted-Pair transceiver module
into the Switch 212M/224M.
Do not install any 100VG transceiver modules in this slot.
Installing the Switch 212M and 224M
Installation Procedures
Blue color bar with "100T" in it,
and the correct model number
identifies a correct transceiver
for the Switch 212M and 224M
2-5