Install An Optional Transceiver - HP ProCurve 2224 Installation Manual

2. Install An Optional Transceiver

Install an optional transceiver module into the transceiver slot as shown in
the illustration below, or by following the instructions in the manual that
comes with the transceiver.
The slot cover can be removed with either a flat-bladed or Torx T-10 screw-
driver. Retain the slot cover for future use.
C a u t i o n
To avoid damage to circuitry in the switch and any transceiver
modules, always unplug the power from the switch before installing or
removing a transceiver module into or from the transceiver slot.
If you do not install an optional transceiver, make sure that the cover plate is
still attached over the slot for safe operation and proper switch cooling.
Installing a Transceiver
Supported Transceiver Model: Install only the HPJ3193B 100Base-FX
Fiber-Optic Transceiver Module into the transceiver slot.
C a u t i o n
Make sure you install only the "B" model or later version of the
100Base-FX Fiber Optic transceiver module into the Switch 2224.
Do not install any 100Base-TX twisted-pair, older 100Base-FX, or
100VG transceiver modules in this slot.
When the correct transceiver is installed in the switch, and the switch is
powered on, the transceiver is used as port 1 for the switch. This is indicated
by the lighting of the LED labeled "100FX Port Used as Port 1" near the trans-
ceiver. The fixed RJ-45 port labeled "1X" is disabled when a transceiver is used.
Installing the Switch 2224
Installation Procedures
Blue color bar with "100T" in it,
and the correct model number
identifies a correct transceiver
for the Switch 2224
2-5