HP ProCurve 224 Installation Manual page 25

2.
.
partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
3.
.
lower switch with
mounting brackets
onto the partially
installed screw
Partially install a screw (5/8-inch number 12-24) into the top hole of a pair
of holes that are 0.5 inches apart in each rack/cabinet upright as shown
in the illustration below. Ensure that the screws are at the same level in
each upright.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws. Tighten these screws-be careful not to
overtighten them.
Installing the Switch 212M and 224M
Installation Procedures
2-9