Front Of The Switches; Network Ports - HP ProCurve 224 Installation Manual

Introducing the HP ProCurve Switch 212M and 224M

Front of the Switches

Front of the Switches
Port
Power Fault
LEDs
LED
LED
Console port
Reset and Clear
buttons

Network Ports

All the fixed twisted-pair ports are wired as MDI-X. Therefore, to connect end
nodes or other MDI-type devices to these ports, use "straight-through" twisted-
pair cable; to connect hubs, switches, or other MDI-X-type devices to these
ports, use "crossover" twisted-pair cable. See appendix B, "Cables and
Connectors" for descriptions of these cables.
The cabling to the transceiver port depends on the type of transceiver
installed. For more information, refer to the manual that came with the
transceiver.
1-2
10/100Base-T ports:
- one transceiver slot
- one fixed RJ-45
Mode button and
indicator LEDs
12 or 24 10Base-T RJ-45 ports
one fixed 10/100Base-TX RJ-45 port
one 100Base-T transceiver slot for installing an HP 10/100Base-TX or
100Base-FX transceiver
10Base-T RJ-45 ports
10Base-T RJ-45 ports