Controller Functions - Grizzly G0894 Owner's Manual

I
Figure 5. Hand-held controller.
I. Controller: Controls machine functions.

Controller Functions

The following commands are used for the basic
navigation of the machine and controller. Additional
functions can be accessed with multi-button com-
mands, see Using Advanced Controls on Page
30 for more information.
Figure 6. Controller buttons.
X+ or 1: Moves spindle motor along X-axis in
positive direction. Scrolls menu up. Input for "1".
Y+ or 2: Moves spindle motor along Y-axis in
positive direction. Increases feed rate. Scrolls
sub-menu up. Input for "2".
Model G0894 (Mfd. Since 05/19)
Z+ or 3: Moves spindle motor along Z-axis in
positive direction. Increases spindle speed during
process. Input for "3".
XY->0 or 4: Sets work origin of X- and Y-axes
(see Page 28). Input for "4".
X- or 5: Moves spindle motor along X-axis in neg-
ative direction. Scrolls menu down. Input for "5".
Y- or 6: Moves spindle motor along Y-axis in
negative direction. Decreases feed rate. Scrolls
sub-menu down. Input for "6".
Z- or 7: Moves spindle motor along Z-axis in
negative direction. Decreases spindle speed dur-
ing process. Input for "7".
Z->0 or 8: Sets work origin of Z-axis (see Page
28). Input for "8".
HOME or 9: Returns all axes to home position
(see Page 28). Input for "9".
HIGH/LOW or 0: In manual mode, selects high
or low speed for axis movement. Input for "0".
ON/OFF or (.): Turns spindle ON or OFF . Input
for decimal point.
MENU or (-): Enters setup menus. Input for the
negative symbol.
ORIGIN or OK: Returns all axes to work origin
(see Page 28). Confirms motions, inputs, or
operations.
MODE: Toggles between the three jogging
modes: Continuous, Step or Distance.
RUN/PAUSE or DELETE: Runs or pauses pro-
cessing. Used to load a program from either the
USB drive or internal memory.
STOP or CANCEL: Stops a running program.
Cancels commands.
-5-