aerauliqa QR120P-I Installation, Use & Maintenance Manual page 27

8.2 Description of Components
Fans
The fans have external rotor motors of EC type which can be steplessly controlled individually between 10-100%. The motor
bearings are life time lubricated and maintenance free. It is possible to easily disconnect and replace the fans if necessary.
Filters
The 2 filters are of filter quality G4 for both the supply air and extract air filter.
The filters need to be cleaned regularly (and replaced when polluted) during maintenance. New sets of filters can be acquired
from your installer or wholesaler.
Heat exchanger
The unit is equipped with a highly efficient, counter-flow plate heat exchanger. Supply air temperature is therefore normally
maintained without adding additional heat. The heat exchanger is removable for cleaning and maintenance during service.
Condensation drainage
Depending on the relative humidity in the extract air, condensation may occur on the cold surfaces of the heat exchanger (Table.
6.b). The condensate water is led out through drainage pipe.
Thermistor
Temperature probe to implement temperature dependent functions.
8.3 Maintenance
Make sure that the mains supply to the unit is disconnected before performing any installation, service, maintenance or
• Keep the unit surface free from dust.
• Once every 3 months (fixed period), the unit warns the user to perform the filter maintenance (Fig. 7.b - ). The actual need
to perform this operation may vary depending on indoor and outdoor ambient conditions.
• Clean the filters every 3 months with a vacuum cleaner (Fig. 8.b-c-d).
• Press the CTRL-V1 button
• Replace the filters every year.
Fig. 8.b
Fig. 8.d
e
(Fig. 7.b) to reactivate the filter alarm.
MANUTENZIONE ORDINARIA
MANUTENZIONE STRAORDINARIA
WARNING
electrical work!
Fig. 8.c
k
27