Delete A Tenant Code; Clear All Tenants - PACH & COMPANY AeGIS NPB9000P Series Installation And Programming Manual

FUNCTION CODE
22

DELETE A TENANT CODE

• To delete, you must know the
tenant code (directory code) that you
assigned on function code 20.
• If you do not know use Function
Code 78 to find the tenant code.
NOTE: Function Code 78 cannot be
used if you program a tenant with
NO NAME on Function Code 20.
23

CLEAR ALL TENANTS

Pach and Company
AeGIS NPB9000P Series
Step 6 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 22 then press # and the display shows
Step 3 Enter the tenant code to be deleted then press #, the display shows
Step 4 Enter 5, the display shows
OR
then the display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 23 then press # and the display shows
Step 3 Enter 1 for YES then press # to continue the display shows
or 0 for NO then press # to cancel and proceed to step 5
Step 4 Enter 5 and the display shows
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
XXXX= tenant code (directory code)
if tenant code exists, proceed
to step 5
if tenant code does not exist
proceed to step 5
proceed to step 4
Page 21
06/20/11