Table of Contents
Advertisement
SuperServer 6039P-TXRT User's Manual
UID/Overheat (OH)/Fan Fail
Connect an LED cable to UID/OH/Fan Fail connections on pins 7 and 8 of JF1 to provide
front UID LED indication and warnings for chassis overheat/fan failure. Refer to the table
below for pin definitions.
Power Fail LED
The Power Fail LED connection is located on pins 5 and 6 of JF1. Refer to the table below
for pin definitions.
Reset Button
The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset
switch on the computer case to reset the system. Refer to the table below for pin definitions.
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both
pins will power on/off the system. This button can also be configured to function as a suspend
button (with a setting in the BIOS - see Chapter 4). To turn off the power in the suspend
mode, press the button for at least 4 seconds. Refer to the table below for pin definitions.
UID/Overheat (OH)/Fan Fail
Pin Definitions (JF1)
Pin#
Definition
7
Front UID LED
8
OH/Fan Fail LED
rrr
Power Fail LED
Pin Definitions (JF1)
Pin#
Definition
5
3.3V
6
PWR Supply Fail
Reset Button
Pin Definitions (JF1)
Pin#
Definition
3
Reset
4
Ground
Power Button
Pin Definitions (JF1)
Pin#
Definition
1
Signal
2
Ground
54
Advertisement
Table of Contents
