Supermicro SuperServer 6039P-TXRT User Manual page 74

SuperServer 6039P-TXRT User's Manual
change the P-State coordination type for all hardware components only. Select SW_ALL
to change the P-State coordination type for all software installed in the system. Select
SW_ANY to change the P-State coordination type for a particular software program
specified by the user in the system. The options are HW_ALL, SW_ALL, and SW_ANY.
Turbo Mode (Available when Intel® EIST Technology is enabled)
Select Enable to use the Turbo Mode to boost system performance. The options are
Disable and Enable.
Hardware PM State Control
(Available when Power Technology is set
to Custom)
Hardware P-States
This feature enables the hardware P-States support. The options are Disable, Native
Mode, Out of Band Mode, and Native Mode with No Legacy Support.
CPU C State Control
(Available when Power Technology is set to
Custom)
Autonomous Core C-State
Use this feature to enable the autonomous core C-State control. The options are Dis-
able and Enable.
CPU C6 report
Select Enable to allow the BIOS to report the CPU C6 State (ACPI C3) to the operating
system. During the CPU C6 State, the power to all cache is turned off. The options are
Disable, Enable, and Auto.
Enhanced Halt State (C1E)
Select Enable to use Enhanced Halt-State technology, which will significantly reduce
the CPU's power consumption by reducing the CPU's clock cycle and voltage during a
Halt-state. The options are Disable and Enable.
Package C State Control
(Available when Power Technology is set to
Custom)
Package C State
This feature allows the user to set the limit on the C-State package register. The options
are C0/C1 state, C2 state, C6 (non Retention) state, C6 (Retention) state, No Limit, and
Auto.
74