Supermicro SuperServer 6039P-TXRT User Manual page 90

SuperServer 6039P-TXRT User's Manual
SATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
SATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0~ Port 7
This item displays the information detected on the installed SATA drive on the particular SATA
port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (SATA Port 0~ Port 7)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (SATA Port 0~ Port 7)
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
SATA Device Type (SATA Port 0~ Port 7)
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH sSATA Configuration
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel® PCH chip
The options are Enable and Disable.
Configure sSATA as
Select AHCI to configure a SATA drive specified by the user as an AHCI drive. Select RAID
to configure a SATA drive specified by the user as a RAID drive. The options are AHCI and
RAID.
SATA HDD Unlock
Select Enable to unlock the HDD password. The options are Disable and Enable.
90
.