Hdd Led; Nic1 Led; Nic2 Led; Overheat/Fan Fail Led - Supermicro SUPERSERVER 6035B-8 User Manual

HDD LED

The HDD (IDE Hard Disk Drive) LED
connection is located on pins 13 and
14 of JF1. Attach the IDE hard drive
LED cable to display disk activity.
Refer to the table on the right for pin
defi nitions.

NIC1 LED

The NIC1 (Network Interface Control-
ler) LED connection is located on pins
11 and 12 of JF1. Attach the NIC1
LED cable to display network activity.
Refer to the table on the right for pin
defi nitions.

NIC2 LED

The NIC2 (Network Interface Control-
ler) LED connection is located on pins
9 and 10 of JF1. Attach the NIC2
LED cable to display network activity.
Refer to the table on the right for pin
defi nitions.
Overheat/Fan Fail LED (OH)
Connect an LED to the OH connection
on pins 7 and 8 of JF1 to provide ad-
vanced warning of chassis overheat-
ing or fan fail. Refer to the table on
the right for pin defi nitions.

Power Fail LED

The Power Fail LED connection is
located on pins 5 and 6 of JF1. Refer
to the table on the right for pin defi ni-
tions. This only applies to redundant
power supplies and so does not apply
to the 6035B-8.
Chapter 5: Advanced Serverboard Setup
Pin Defi nitions (JF1)
Pin#
13
14
Pin Defi nitions (JF1)
Pin#
11
12
Pin Defi nitions (JF1)
Pin#
9
10
OH/Fan Fail LED
Pin Defi nitions (JF1)
Pin#
7
8
Pin Defi nitions (JF1)
Pin#
5
6
5-13
HDD LED
Defi nition
Vcc
HD Active
NIC1 LED
Defi nition
Vcc
Ground
NIC2 LED
Defi nition
Vcc
Ground
Defi nition
Vcc
Ground
Power Fail LED
Defi nition
Vcc
Ground