DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Bandsaw Speed Table
Model
Min (Small Pulley)
AW1950B
1) The bandsaw drive pulley has two speed positions. To
change the speed, follow the instructions below. Open the
bandsaw wheel doors and release the belt tension on the
AW1950B bandsaw, loosen the motor Hex bolt, see fig 83 and
pull the motor up.
Fig 83-84
Loosen
Max (Large Pulley)
660m/min
840m/min
Hex bolt
Tension
Hex bolt
CHANGING THE SAW BLADE
WARNING! BE VERY CAREFUL WHEN
REMOVING THE BELT NOT TO TRAP
YOUR FINGERS!
NOTE: MAKE SURE THE BELT IS NOT
TENSIONED TO TIGHTLY TO CAUSE IT
TO GET HOT.
2) With the drive belt loose, carefully reposition the drive belt,
see fig 85. NOTE: Make sure the belt is seated correctly in
one of the drive pulley grooves. With the belt repositioned,
push the motor down on the 'AW1950B' and tighten the bolt
to retention, see fig 84. Close the wheel doors.
27
Fig 85
Pulley grooves