Advertisement
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
1) Put the table back to the level position if it has been tilted.
Open up all blade guides so that they are clear of the blade
and open the wheel doors. Set the upper blade guide assembly
approximately midway in the throat so the top of the blade
guide is level with the centre of the top drive wheel, see fig 71.
Remove the table insert.
2) Remove the table stabilising bolt, slacken the blade tension
by turning the blade tensioning wheel anti-clockwise, until the
blade can be easily slipped off the wheels, see fig 72.
Fig 71-72
3) Remove the lower blade guide guard and place safely aside,
see fig 73-74. Remove the blade carefully, "wiggling" it clear of
the upper blade guard and out through the slot in the table, 75.
Fig 73-74-75
Top wheel
Blade guide
CHANGING THE SAW BLADE
4) This is a good time to clean out the interior of the machine;
remove the impacted 'crud' from the tyres. The pivots and the
slides of the top wheel mounting assembly and the captive
stub axle of the drive belt tensioner in its slot could likewise
be lightly oiled, see fig 76-77-78.
25
Table slot
Fig 76-77-78
Continues over...
Advertisement
