Advertisement
SETTING UP THE SAW
Fig 57
Grub screws
5) Lower the table down and check that the pointer of the tilt
scale reads zero, if not, loosen the Phillips screw and reposition
the pointer, see fig 58.
Fig 58
Pointer
Setting the Fence & Scale
The fence scale does not come pre-mounted to the fence rail
and needs to be stuck in place. NOTE: Before sticking the
scale down make sure the table and fence assembly is
square to the blade. Follow the instruction below.
Fig 59
Mounting plate
1) Line up the fence (4) with the edge of the tables 'T' slot and
press down the locking handle, see fig 59. If the fence is out of
alignment, loosen the two Hex screws either side of the fence
clamping assembly. Adjust the fence until its in alignment with
the 'T' slot, retighten the Hex screws, see fig 60.
2) Position the fence against the blade and lock in place &
remove the fence rail end cap, see fig 61. Find a pencil and
draw a line on the fence rail to mark the position of the fence
assembly. Using a rule or vernier caliper, measure the distance
between the magnifying glass pointer and pencil line, see fig
62-63.
'T' Slot
22
Remove the fence
rail end cap
Fig 60
Hex screw
Fig 61
Fig 62-63
Advertisement
