Cleaning And Storage; Operating Notes - Wilfa POWER FUEL BPF-1200S Instruction Manual

CLEANING AND STORAGE

EN
• Unplug the appliance from the wall socket.
• Do not immerse the base unit or power cord in water or other liquids.
• Clean surface of the blender jug with a soft cloth or sponge. The measuring
cup can be disassembled for cleaning.
• The blender jug can be rinsed with water. It can also be cleaned by pouring
2 cups of water into the blender jug, closing the lid and then operating the
blender in Pulse Mode. Then pour out the water and dry with soft cloth.
• After cleaning, place the blender jug on its side or upside down (Note 1) to
dry. Do not immerse the whole jug in water.
• Clean the base unit with a soft cloth. NEVER immerse it in water or other
liquid.
Note: Tamper and blender jug shall not be washed in a dishwasher.
Note: If you place the blender jug in upside down position, please remove
residual water with a dry cloth. Do not leave it close to the sink or basin in order
to avoid water spraying onto the bottom part of the jug. This may cause the
bearing to rust, thus affecting the performance of the blender

OPERATING NOTES

• The blender cannot be operated if:
– The jug is not firmly positioned on the base.
– The speed dial is turned to variable speed before the jug is positioned firmly
on the base.
– The jug is removed during operation and put back again.
• You need to turn the speed dial back to the "OFF" (OFF) position and make
sure the jug is positioned firmly on the base. This will reset the blender.
• If the motor is forced to slow down because of food that is too big in size or
if there is not enough liquid in the jug, and if it operates for a long period,
the temperature monitoring system will trigger and stop the operation of
the motor. The red LED will blink at a rate of 2 Hz. In this case, unplug the
blender and leave it in a place with good ventilation to cool down the motor
temperature for 45 minutes. The system will reset and the blender can be
used again.
• During operation, close the lid tightly to avoid scalding due to spraying of hot
liquids.
• Keep hands and utensils out of the container while the motor is running to
INSTRUCTION MANUAL · POWER FUEL
12