Lid, Measuring Cup; Cleaning & Storage; Operating Notes - Wilfa BPF-1200S Operating Instructions Manual

10 10

Lid, Measuring Cup

„ Insert the measuring cup in the lid by aligning the two tabs in the slots
on the lid and twisting to lock. Then push the lid onto the blender jug to
close it. To open the lid, pull the flap up.
Cleaning & Storage
„ Unplug the appliance from the wall socket.
„ Do not immerse the base unit or power cord in water or other liquids.
„ Clean surface of the blender jug with a soft cloth or sponge.
The measuring cup can be disassembled for cleaning.
„ The blender jug can be rinsed with water. It can also be cleaned by
pouring 2 cups of water into the blender jug, closing the lid and then
operating the blender in Pulse Mode. Then pour out the water and dry
with soft cloth.
„ After cleaning, place the blender jug on its side or upside down (Note 1)
to dry. Do not immerse the whole jug in water.
„ Clean the base unit with a soft cloth. NEVER immerse it in water or other
liquid.
Note: Tamper and blender jug shall not be washed in a dishwasher.
Note 1: If you place the blender jug in upside down position, please remove residual
water with a dry cloth. Do not leave it close to the sink or basin in order to avoid water
spraying onto the bottom part of the jug. This may cause the bearing to rust, thus
affecting the performance of the blender

Operating notes

„ The blender cannot be operated if:
– The jug is not firmly positioned on the base.
– The speed dial is turned to variable speed before the jug is positioned
firmly on the base.
– The jug is removed during operation and put back again.
„ You need to turn the speed dial back to the "OFF" (OFF) position and
make sure the jug is positioned firmly on the base. This will reset the
blender.
„ If the motor is forced to slow down because of food that is too big in
size or if there is not enough liquid in the jug, and if it operates for a