Table of Contents
Advertisement
40
Operation Section
Engine and Aftertreatment
10. Before start-up, test the cooling system for a 3
percent to a 6 percent concentration of coolant
conditioner. Add liquid coolant conditioner or a
coolant conditioner element, if equipped.
Test the coolant mixture for proper nitrite level. If
necessary, adjust the coolant mixture.
Prime the engine with clean diesel fuel before
starting.
11. Ensure that the cooling system is clean. Ensure
that the system is full. Ensure that the system has
the correct amount of supplemental cooling
system conditioner.
12. On the first day of operation, check the entire
engine several times for leaks and correct
operation.
Remove Aftertreatment from Storage
DEF has a limited life, refer to table 2 for the time and
temperature range. DEF that is outside this range
MUST be replaced.
On removal from storage the DEF quality in the tank
must be tested with a refractometer. The DEF in the
tank must meet the requirements defined in ISO
22241-1 and comply with table 2 .
1. If necessary, drain the tank and fill with DEF that
meets ISO 22241-1.
2. Replace the DEF filter, refer to this Operation, and
Maintenance Manual, "Diesel Exhaust Fluid Filter-
Clean/Replace".
3. Ensure that the drive belt is correctly installed.
Ensure that all engine coolant and engine oil has
the correct specification and grade. Ensure that
the coolant and the engine oil are at the correct
level. Start the engine. If a fault becomes active
turn off the engine, allow 2 minutes for the DEF
system to purge, then restart the engine.
4. If the fault continues to stay active, refer to
Troubleshooting for more information.
Table 2
DEF Storage
Temperature
10° C (50° F)
25° C (77° F)
30° C (86° F)
35° C (95° F)
(1)
(1)
At 35° C, significant degradation can occur. Check every batch
before use.
Duration
36 months
18 months
12 months
6 months
M0087475-06
Advertisement
Table of Contents
