Perkins 1706EA-E93TA Operation And Maintenance Manual page 110

Industrial engines
Table of Contents

Advertisement

110
Maintenance Section
Engine Air Cleaner Service Indicator - Inspect
Replace the dirty air cleaner elements with new air
cleaner elements. Before installation, the air cleaner
elements should be thoroughly checked for tears
and/or holes in the filter material. Inspect the gasket
or the seal of the air cleaner element for damage.
Maintain a supply of suitable air cleaner elements for
replacement purposes.
Dual Element Air Cleaner
The dual element air cleaner contains a primary air
cleaner element and a secondary air cleaner
element.
When the engine is operating in environments that
are dusty or dirty, air cleaner elements may require
more frequent replacement.
If equipped, perform maintenance on the pre-cleaner
or the dust bowl before performing maintenance on
the air filter elements.
Illustration 99
Typical example
Note: Do not allow dirt to enter the air system during
replacement of the air filter elements.
1. Clean the outer casing of the air cleaner before
removing the end cover (3).
Note: Before removal, check the orientation of the
end cover (3). Some air cleaners the end cover must
be installed in the correctly aligned position.
2. Release the clips (4) and remove the end cover (3)
from air cleaner body (1).
3. Remove the primary air filter element (2) and
remove the secondary air filter element (not
shown) from air cleaner body (1). Ensure that the
inner body of the air cleaner is clean and free from
dirt. Ensure that the inner of the air cleaner cover ,
(3) is clean and free from dirt.
4. Install a new secondary air filter element (not
shown). Install a new primary air filter element (2)
and install end cover (3). Ensure that the clips (4)
are located securely.
Engine Air Cleaner Service
Indicator - Inspect
(If Equipped)
Some engines may be equipped with a different
service indicator.
Some engines are equipped with a differential gauge
for inlet air pressure. The differential gauge for inlet
air pressure displays the difference in the pressure
that is measured before and after the air cleaner
element. As the air cleaner element becomes dirty,
the pressure differential rises. If your engine is
equipped with a different type of service indicator,
follow the OEM recommendations in order to service
the air cleaner service indicator.
The service indicator may be mounted on the clean
side of the air cleaner housing or in a remote
location.
g06043462
Illustration 100
Typical service indicator
Observe the service indicator. The air cleaner
element should be cleaned or the air cleaner element
should be replaced when one of the following
conditions occur:
• The yellow diaphragm enters the red zone.
• The red piston locks in the visible position.
M0087475-06
i08397637
g00103777

Advertisement

Table of Contents
loading

This manual is also suitable for:

1706j-e93ta

Table of Contents