Download Print this page

Omcan VP-CN-0600 Instruction Manual page 9

Table of Contents

Maintenance

4. Remove the forcing screws from the two sides of the sealing bar with an Allen Key, then remove the

heating wire.

5. Put one side of a new heating wire into the fastener groove and tighten it with the Allen Key.

6. Put the other side of the heating wire into the other side fastener groove, then screw it with the Allen Key.

7. Fasten the heating wire, then cut the excess heating wire.

Table of Contents

Need help?

Do you have a question about the VP-CN-0600 and is the answer not in the manual?

43632