Device Name - Datalogic BC9 0 Series Software Reference Manual

Device Name

Device Name
This parameter is used to uniquely identify one BC9180™ from other
Datalogic devices during the Product Discovery service initiated by Alad-
din. This feature will identify a Hostname and discovery name to corre-
spond to the address of a device connected to a network. .
$ETDN
Set Device Name
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
Ethernet Software Reference Guide
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix B, Keypad
character(s).
If less than the expected string of 32 characters is
selected, scan the ENTER/ EXIT bar code to termi-
nate the string. Exit programming mode by scan-
ning the ENTER/EXIT barcode again.
BC9180-433(910)(BT) [BASE_SERIAL_NUMBER]
Enter/Exit Programming Mode
representing your desired
~
CANCEL
23