Table of Contents
Advertisement
Figure 3
After selecting the desired parameter, click
tion. The cradle will be reset and then start up with the new configured
parameter.
Selecting a Non‐Ethernet interface
Selecting a non-Ethernet interface should not be needed in any Ethernet
application, but if you want do it for service purposes, download the
Quick Reference Guide (QRG) from the Datalogic website.
To restore the Ethernet interface, scan the bar code below.
NOTE
ETHERNET
Ethernet Host interface
For other interfaces, you can download the Product Reference Guide
(PRG) or Quick Reference Guide (QRG) on the Datalogic website:
www.datalogic.com.
NOTE
Ethernet Software Reference Guide
.
Webserver configuration screen
Unlike some programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT scan an
ENTER/EXIT bar code prior to scanning an interface selection bar code.
Select Ethernet Standard Interface
The default interface for the BC9180™ base station/charger is Ethernet
Standard.
BC9180™ Startup and Connection to Ethernet Net-
Apply
to finish the configura-
FEATURES
Set
Ethernet
Standard Features
starting on
page 16
7
Advertisement
Table of Contents
