Table of Contents
Advertisement
Setup
BC9180 Configuration
The BC9180 configuration can be performed in several ways, by using:
• Datalogic Aladdin software
• Configuration Bar Codes
• Webserver Configuration
Datalogic Aladdin™ software
After connection, the BC9180 can be configured by sending configura-
tion strings from the Datalogic Aladdin™ via the Ethernet interface.
Figure 2. Datalogic Aladdin™ Configuration Screen
Configuration Bar Codes
Link the cradle and the reader using the procedures described in the
PowerScan
pairing is complete, you can configure the BC9xx0 cradle by scanning
configuration bar codes from this manual. See Ethernet Host Interface
Parameters Only, starting on page 15.
To configure the BC9180 using the PowerScan
the cradle with the Bind command), follow the procedure for the interface
selected.
Webserver Configuration
After successful connection to the Ethernet network, you can configure
the BC9180™ cradle parameter by using any commercial Web Browser
accessing the URL:
Then select
NOTE
6
™
PM9500 or PBT9500 Quick Reference Guide (QRG). Once the
http://<BC9180™_IP_Address>.
Configuration
from the menu on the left.
You can also use Aladdin software to obtain the IP address of the cradle
after the cradle is connected to the network.
Web Server configuration is always available when the BC9180™ is con-
nected to the network, REGARDLESS of the interface selection.
™
9500 reader (paired to
BC9180™ Base Station/Charger
Advertisement
Table of Contents
