Table of Contents
Advertisement
Enter/Exit Programming Mode
Gateway Address
A gateway is a router that connects separate IP network segments. For
example, a network segment might need a gateway to connect it to
another network segment, a wide area network (WAN), or to the Internet.
This feature specifies the address of a local IP router on the same net-
work as the BC9180™, used to forward traffic to destinations beyond the
local network. The value in each field must be a number from 0
through
$CETGA
Set Gateway address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
20
255.
Default Gateway address = C0A8BBFE,
hexadecimal representation of 192.168.187.254
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by 8
digits (in hex) from the Alphanumeric characters in
representing your desired
Appendix B, Keypad
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode again.
CANCEL
BC9180™ Base Station/Charger
Gateway Address
~
Advertisement
Table of Contents
