Table of Contents
Advertisement
Malfunction
Slurping, rhythmic
suction sound.
wrinkling.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
Cause and Troubleshooting
Pump is active, the water is being pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
For the next wash, set a lower spin
▶
speed in.
The load quantity is too high.
During the next wash, reduce the load
▶
quantity.
The wrong program has been selected for the type of
fabric.
Select a suitable program for the type of fabric.
▶
→ "Programs", Page 27
Low spin speed is set.
For the next wash, set a higher spin
▶
speed in.
Start the program Centrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and water drain
▶
feed hose is not kinked or pinched.
The unbalance detection system has aborted the spin
due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Note: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
Start the program Centrifuge.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Note: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
Start the program Centrifuge.
▶
Troubleshooting NL
69
Advertisement
Table of Contents
