Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the
wash cycle.
66
Cause and Troubleshooting
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Unauthorized extension mounted on the water drain
hose.
Remove unauthorized extensions to the wa-
▶
discharge hose. Connect device
Start/Refill
Press Start/Refill
▶
The strainers in the water supply are clogged.
Clean the strainers in the water supply → Page 58.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Note: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
can lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Note: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system will add an extra rinse if the
foam is too high.
No error - no action required.
▶
was not pressed.
.
Advertisement
Table of Contents
