Table of Contents
Advertisement
NL Home Connect
Required: The Smart Energy system
(energy manager) can only start the
device when the Smart Energy
system (energy manager) and the
device are connected.
Set the desired programme.
1.
Press - Ready in + and set the
2.
desired time period.
Press Start/Refill
3.
Press Control via App
4.
a The display shows and the
Flexstart is activated. The device is
waiting for a remote start via the
Smart Energy system (energy
manager).
aWhen the display shows the weather
If the time goes to eg 8 h, the
Smart Energy system (energy
manager) has set a time at which
the device will start.
aWhen the Smart Energy system
tem (energy manager) If the
appliance does not start within the
set time, the appliance starts the
program automatically before the
set time has elapsed. The program
ends when this time frame is over.
Note
For safety reasons, the Flex
Start is covered by the
following conditions
deactivated:
¡ Press Start/Refill
¡ Open the door.
¡ Turn off the device.
¡ Power cut.
48
16.5 Activate WiFi on the device
Note: The energy consumption
increases compared to the values
indicated in the consumption value
tables when Wi-Fi is activated.
Approx. 3 s onControl via App
1.
to press.
.
Set program to position 4.
.
2.
a The display shows Con reflected
to give.
Press Start/Refill
3.
the display on displays.
aWiFi is activated.
Note: The device does not turn off
automatically when WiFi is activated.
16.6 Deactivate WiFi on the
device
On for at least 3 seconds Control
1.
via App press.
Set program to position 4.
2.
a The display shows Con reflected
to give.
Press Start/Refill
3.
the display OFF displays.
aWiFi is deactivated.
Note: If the WiFi is deactivated and
your device was previously connected
to your home network, the
connection is automatically re-
.
established when the WiFi is switched
on again.
16.7 Software update
Required: The display shows UPd
displayed.
Approx. 3 s onControl via App
1.
to press.
until
until
Advertisement
Table of Contents
