Table of Contents
Advertisement
Malfunction
lights up.
flashes.
All other error codes. Malfunction
Device not working.
Cause and Troubleshooting
The detergent drawer is not closed as far as it will go.
Push the detergent drawer into the appliance as far as it will go.
▶
ready.
Pump unit is not installed.
Place the pump unit in the detergent drawer.
1.
→ "Cleaning the detergent drawer",
Page 52
Push the detergent drawer into the appliance as far as it
2.
will go.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 44.
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Temperature is too high.
Wait for the temperature to drop.
▶
→ " program cancel", Page 42
▶
Water level is too high.
Start the program pump down.
▶
Laundry is wedged in the door.
Open the door again.
1.
Remove trapped laundry.
2.
Close the door.
3.
To start the program, press Start/Additional
4.
.
to fill
Door is not closed.
Close the door.
1.
To start the program, press Start/Additional
2.
.
to fill
Please contact customer service.
▶
→ "Service", Page 74
Mains plug of the power cable is not plugged in.
Connect the appliance to the mains.
▶
Troubleshooting NL
63
Advertisement
Table of Contents
