Table of Contents
Advertisement
Malfunction
Door cannot be
opened.
Washing water is not
pumped out.
Cause and Troubleshooting
is activated.
Resume the program by Centrifuge or off-
▶
pumps to choose and press Start/Refill
know.
→ "Resume program on rinse hold", Page 42
Temperature is too high.
Wait for the temperature to drop.
▶
→ " program cancel", Page 42
▶
Water level is too high.
Start the program pump down.
▶
Power cut.
Open the door with the emergency release.
▶
→ "Emergency release", Page 72
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and water drain
▶
feed hose is not kinked or pinched.
Drain pump is clogged.
→ " Cleaning the drain pump", page 54
▶
is activated.
Resume the program by Centrifuge or off-
▶
pumps to choose and press Start/Refill
know.
→ "Resume program on rinse hold", Page 42
Water drain hose is connected too high.
Mount the water drain hose at a maximum of 1 meter
▶
height.
Pump cover not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 44.
Troubleshooting NL
too busy-
too busy-
65
Advertisement
Table of Contents
