Table of Contents
Advertisement
NL Troubleshooting
Malfunction
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:10 / -00 / -10 /
- 20"
62
Cause and Troubleshooting
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Unauthorized extension mounted on the water drain
hose.
Remove unauthorized extensions to the wa-
▶
discharge hose. Connect device
Drain pump is clogged.
→ " Cleaning the drain pump", page 54
▶
Drain pump is clogged.
→ " Cleaning the drum", page 52
▶
if the fault is displayed again,
→ " Cleaning the drain pump", page 54
▶
Inlet opening of the rubber sleeve is clogged.
→ " Clean the inlet opening in the rubber sleeve",
▶
Page 57
Pump of the intelligent dosing system is blocked.
Switch off the device.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer",
Page 52
If the indication reappears, enable the service.
3.
→ "Service", Page 74
Note: You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
→ "Keys", Page 24
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
Clean the strainers in the water supply → Page 58.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
Advertisement
Table of Contents
