Baud Rate; Figure 5-5 Keyboard Setup Screen; Table 5-4 Resetting The Baud Rate - Will Burt POSITIONIT PI-150 Operator's Manual

5.2.4 Baud Rate

When the controller is powered on, the baud rate will be displayed. The baud rate should be
2400 bps. If necessary, reset the baud rate to 2400. A quick guide to resetting the baud rate can
be found in Table 5-4.
1. Keyboard setup
2. Dome setup
3. Protocol select
4. Exit menu
To reset the baud rate:
1. Press [Menu] for (2) seconds. The Menu screen will appear (Figure 5-2).
2. While remaining on <Keyboard setup>, move the joystick to the right to go to the
submenu. The Keyboard setup screen (Figure 5-5) will appear. The number beside <2.
Set baudrate:> may vary.
3. Navigate to <Set baudrate> and move the joystick to the right. The screen will remain
the same, but the number beside <2. Set baudrate:> will be selected.
4. Move the joystick forward or backward to adjust the baud rate.
5. Move the joystick to the right to save the baud rate. <Success!> will briefly flash at the
bottom of the LCD screen and the display will return to the Menu screen (Figure 5-2).
The setting is saved.
TP-5129001-J
January 2022

Table 5-4 Resetting the Baud Rate

1. Set KB ID(1-64):
2. Set baudrate: 2400
3. Joy-calibrate
4. About Keyboard
1. Set KB ID(1-64):
2. Set baudrate: 2400
3. Joy-calibrate
4. About Keyboard

Figure 5-5 Keyboard Setup Screen

P OSITION
1. Set KB ID(1-64):
2. Set baudrate: 2400
3. Joy-calibrate
4. About Keyboard
I PI-150 PI-75
T AND
Move the joystick down
until the number beside
<Set baudrate> reads
2400, then move the
joystick right.
5-5