Before Using - Carscop CCTR-805 Manual

3g car gps tracker
Table of Contents

Advertisement

Product
CCTR-805

Before Using

1.
Power ON / OFF
Turn the switch to the on position beside the tracker, the tracker will power on, if the tracker battery is low,
the power & GND wire connect to car battery is OK, after the tracker is powered on, the LED will flash, if the
Green LED flash once every 4 seconds, it means the tracker work well, please refer the following 3 for detail
LED flash indicator.
2.
Install SIM card (Micro SIM Card)
Open the SIM card room cover, the SIM card holder can be seen, put & push the SIM card to the SIM card
holder, there will be a click sound when the SIM card is locked properly, if the SIM card is not installed properly,
the tracker can not find the mobile phone network signal, please pull out the SIM card and change the SIM
card face to other side and try again. (Pay attention to that the SIM card metal contact pin need face down to
the socket, please refer the following diagram). And then put the SIM card room cover properly.
SIM Card
Holder
LED
Indicator
ON/OFF
Switch
Microphone
Socket
-2-
Wires
SOS Button
Microphone
SIM Bevel Face Out
Metal Pin Face Down

Advertisement

Table of Contents
loading

Table of Contents