HIKVISION DS-2DP0818Z-D User Manual page 12

Table of Contents

Advertisement

You can check whether the activation is completed on the popup window. If activation failed, make
sure that the password meets the requirement and then try again.
5. Change the device IP address to the same subnet with your computer by either modifying the IP
address manually or checking the Enable DHCP checkbox.
6. Input the password and click Save to activate your IP address modification.
 Activation via Client Software
The client software is versatile video management software for multiple kinds of devices.
Get the client software from the supplied disk or the official website, and install the software according
to the prompts. Follow the steps to activate the camera.
Steps:
1. Run the client software and the control panel of the software pops up, as shown in the figure
below.
User Manual of PanoVu Series Network Camera
Figure 1-5 Modify the IP Address
Figure 1-6 Control Panel
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Panovu series

Table of Contents