Omron Sysmac NX701 User Manual page 71

Sysmac Studio
Between Control-
lers
Devices
Programmable Terminals
Servers
*1. Use a CJ-series EtherNet/IP Unit with a unit version of 2.1 or later.
Also, mount the EtherNet/IP Unit to an NJ-series CPU Unit with unit version 1.01 or later, and use Sysmac
Studio version 1.02 or higher.
Refer to the NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501) for information on version up-
grades.
*2. Mount to an NJ-series CPU Unit.
NX-series CPU Unit Hardware User's Manual (W535)
Connection
NJ/NX-series Controller or CJ-series
PLC
Servo Drives, general-purpose
slaves and Vision Systems
Ethernet communications devices
Serial communications devices
DeviceNet slaves
CompoNet slaves
Connections to BOOTP server, DNS
server, or NTP server
2 System Configuration
Connection method
Use the built-in EtherNet/IP port.
Use the built-in EtherNet/IP port or a port on an Eth-
*1
erNet/IP Unit.
Use the built-in EtherCAT port.
Use the built-in EtherNet/IP port or a port on an Eth-
*1
erNet/IP Unit.
Mount a Serial Communications Unit
RS-232C port or RS-422A/485 ports.
*2
Mount a DeviceNet Unit and use DeviceNet.
Mount a CompoNet Master Unit
poNet.
Use the built-in EtherNet/IP port or a port on an Eth-
*1
erNet/IP Unit.
Use the built-in EtherNet/IP port or a port on an Eth-
*1
erNet/IP Unit.
*2
and use
2
*2
and use Com-
2 - 7