3-4
Sysmac Studio
The Sysmac Studio is a Support Software package that provides an integrated development environ-
ment to design, program, debug, and maintain SYSMAC NJ/NX-series Controllers.
This section describes the models and connecting methods of the Sysmac Studio.
3-4-1
Model Numbers
The model numbers of the Sysmac Studio Standard Edition are given in the following table. The model
numbers are different for the media and licenses.
Product
Sysmac Studio
Standard Edition
3-4-2
Connection
With an NJ/NX-series CPU Unit, you can connect the Sysmac Studio online in the following ways.
Configuration
Connecting by USB
• Direct Connection
Sysmac Studio
USB
The connection device does not
need to be specified.
Note Connect a computer and the CPU Unit with a USB 2.0 certified cable. Do not use a USB hub to connect
them.
NX-series CPU Unit Hardware User's Manual (W535)
Configuration software
Sysmac Studio
The following Support Software is
also included.
Network Configurator
CX-Integrator
CX-Protocol
CX-Designer
• Connection to CPU Unit on EtherNet/IP with USB
Number of
Media
user
licenses
DVD
---
Licenses
1
3
10
Sysmac Studio
USB
EtherNet/IP
Directly specify the IP address of the remote device.
3 Configuration Units
Model
SYSMAC-SE200D
SYSMAC-SE201L
SYSMAC-SE203L
SYSMAC-SE210L
3 - 15
3