Table of Contents
Advertisement
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If installed, disconnect the power or data cables from expansion card(s).
Steps
1
Locate the battery socket. For more information, see the
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or removing a
battery.
2
Use a plastic scribe to pry out the system battery.
Figure 98. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 99. Installing the system battery
Next steps
1
If removed, connect the cables to the expansion card(s).
2
Follow the procedure listed in
3
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
4
Enter the correct time and date in the System Setup Time and Date fields.
5
Exit the System Setup.
Safety
instructions.
Before working inside your
After working inside your
system.
system.
System board jumpers and connectors
Installing and removing system components
section.
147
Advertisement
Table of Contents
