Table of Contents
Advertisement
Kit contents
•
Dell part number 6RYJ9 terminal block or equivalent (1)
•
#6-32 nut equipped with lock washer (1)
Required tools
Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated copper wire.
NOTE:
Use alpha wire part number 3080 or equivalent (65/30 stranding).
Required wires
•
One UL 10 AWG, 2 m maximum (stranded) black wire [–(48–60) V DC].
•
One UL 10 AWG, 2 m maximum (stranded) red wire (V DC return).
•
One UL 10 AWG, 2 m maximum, green with a yellow stripe, stranded wire (safety ground).
System cover
Removing the system cover
Prerequisites
1
Follow the safety guidelines listed in
2
Turn off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet and peripherals.
4
If installed,
remove the front
5
Place the system on a flat, stable surface.
Steps
1
Turn the latch release lock to the unlocked position.
2
Press the cover release latch and remove the system cover.
86
Installing and removing system components
Safety
instructions.
bezel.
Advertisement
Table of Contents
